Guide to installation |
Preparation of the area to be decorated
The support where the transfer will be fitted must be dry and clean, without grease or dust.
Beware of injected plastic parts which contain slippery demoulding agents!
Before posing the transfer, we advise degreasing the area to be decorated using a suitable solvent.
Optimal temperature conditions during the installation
The ideal temperature of installation of transfers is between 20° C and 30° C (70° F and 90°F).
The support must be neither too cold (5°C / 40°F minimum – risk of loss of adhesive power) nor too hot (30°C / 90°F maximum – softening of the glue)
Beware of parts stored outside in winter.
Instructions for installation
1 - Prepare the surface to be marked
2 - Remove the white silicon paper backing
3 - Place the transfer on the surface to be marked
4 - Fix the transfer by rubbing it firmly with a
scraper on transfers with a full cover of varnish,
or with a pencil with a debording varnish.
See an example of a final proof
pdf
Download Acrobat Reader
5 - Remove the transparent plastic front support carefully.
|
|
